Terry the G-Man's 1340M in a N frame

Terry wrote;

"Thank you for your web site.
It gave me a lot of info for my project.
I'm building a monster 1340cc Gixer in my 92 750 frame.

I have a 91 1100 bottom end, 89 forked rocker 1100 top end, ported and polished with oversized valves (31mm intake and 27mm exhaust) 130+ cfm head feeding the 1340cc APE gorilla block.
The motor has Carrillo rods and a falicon race balanced and lightened crank.
I'm using the Dyna 2000 programmable ignition with dyna coils and 8mm graphite plug wires.
I'm also developing a ram-air system on it feeding 38mm RS Flatslide carbs with 70mm velocity stacks. It will be filtered from the front of the bike with K&N box filters.
it is 11.6 to 1 compression so I can run super-unleaded in it.

I have also started the bike on a significant weight loss program (Jenny Craig...Ha Ha..)by removing anything thats not needed.
I installed PM wheels Kevlar brake lines airtech body etc.

Anyway, it wont be until spring when I can Dyno the bike.
I need it around 70 degrees F to jet it properly but I will send pictures of the project as it progresses.
APE guesses between 190RWHP to 230RWHP on pump gas.
All naturally aspirated.....for now. I have a turbo kit here as well but I must first try to ride this insane thing first...

more will come later....

Thanks again for your sites help.........

Terry "GMAN" Gulick Boise, ID USA
gman915@micron.net"